JALpower NS SERIES Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Inverter JALpower NS SERIES. JALpower NS SERIES 14. Solar inverter

3.4.6 Wi-Fi Communication

The Wi-Fi communication function is only applied to WiFi box, the detailed configuration instruction can be referred to Wi-Fi

Configuration in the accessory box.

Connection Procedure:

● Take out the interior cable of the inverter.

● Insert cable into the WiFi BOX. please refer to Figure 3.4.6-1.

● Lock the

WiFi

BOX onto the chassis tightly.

3.4.7 Power Limiting device installation

Connection method of

Power Limiting device

CT please refer to Figure 3.4.7-1.

1-White wire

2-Black

wire

Inverter

POWER

RUN

FAULT

NOTE：After installation is completed, please set up power limiting function referring to section 4.5

Figure 3.4.6-1

Switch Board

Router

Figure 3.4.7-1

● Pay attention to the direction of CT when wiring. CT clip should be locked tight. White cable should connect Line 6 and black cable

should connect Line 5. Tighten them with screwdriver. Make sure CT cables connected to the right output phase lines of inverter

when in use.

● Without connection of CT, inverter will show "CT Disconnect". If CT is connected reversely, inverter will show "CT Reverse"when

it enters into on-grid status .

2. Connection Procedure:

● Put the cable through the components in this order: screw cap, one-hole sealing ring, insulation body and sheet metal parts.

● Take the green terminal out of accessory bag. cable should be connected as Figure 3.4.7-1.

● Insert the green terminal into the corresponding interior terminal of the inverter. Pull cable softly to maintain the cable not to be

pulled out.

● Lock the sheet metal parts onto the box and tighten the screw cap.

123456

Function

Line

CT+

CT-

Reserved

Digital output

Figure 3.4.7-2