ENGLISH
Installation
Mounting the appliance
Follow the supplied separate mounting instructions when
installing the appliance.
Children should not perform installation operations. Keep
children away during installation of the appliance. Keep the
packaging materials (plastic bags, polystyrene parts, etc.) out
of reach of children, during and after the installation of the
appliance.
Use protective gloves to perform all unpacking and installation
operations.
The appliance must be handled and installed by two or more
persons.The appliance must be disconnected from the power
supply before carrying out any installation operation.
Electrical connection
Prior to connecting
Check that the voltage on the rating plate corresponds to the
voltage in your home.
The rating plate is on the front edge of the oven (visible when
the door is open).
Do not remove the microwave inlet protection plates located on
the side of the oven cavity walls. They prevent grease and food
particles from entering the microwave inlet channels.
Ensure the oven cavity is empty before mounting.
Ensure that the appliance is not damaged.
Check that the oven door closes firmly against the door support
and that the internal door seal is not damaged. Empty the oven
and clean the interior with a soft, damp cloth. Do not operate
this appliance if it has a damaged mains cord or plug, if it is not
working properly, or if it has been damaged or dropped. Do not
immerse the mains cord or plug in water. Keep the cord away
from hot surfaces. Electrical shock, fire or other hazards may
result.
After connecting
The oven can be operated only if the oven door is firmly closed.
Regulation require that the appliance is earthed.
The manufacturer will accept no responsibility for injury to
persons, animals or damage to objects arising from the
non-observance of this requirement.
The manufacturers are not liable for any problems caused by the
user's failure to observe these instructions.
Failure to observe these instructions may lead to risks. The
Manufacturer declines any liability for injury to persons or
animals or damage to property if these advices and precautions
are not respected.
After unpacking the appliance, make sure that it has not been
damaged during transport. In the event of problems, contact the
dealer or your nearest After-sales Service.
After unpacking the appliance, make sure that the appliance
door closes properly.
In the event of problems, contact the dealer or your nearest
After-sales Service. To prevent any damage, only remove the
oven
from its polystyrene foam base at the time of installation.
During installation, make sure the appliance does not damage
the power cable.
CAUTION: The appliance is not intended to be operated by
means of an external timer or separate remote control system.
After installation, the electrical components must not be
accessible to the user.
For installation to comply with current safety regulations, an
omnipolar switch with minimum contact gap of 3mm is required.
WARNING : The power cable must be long enough for
connecting the appliance, once fitted in its housing, to the main
power supply.
Do not pull the power supply cable.
If the power cable is damaged it must be replaced with an
identical one. The power cable must only be replaced by a
qualified technician in compliance with the manufacturer
instruction and current safety regulations. Contact an authorized
service center.
Do not operate this appliance if it has a damaged mains cord or
plug, if it is not working properly, or if it has been damaged or
dropped. Do not immerse the mains cord or plug in water. Keep
the cord away from hot surfaces.
Do not touch the appliance with any wet part of the body and do
not operate it when barefoot.
For appliances with fitted plug, if the plug is not suitable for you
socket outlet, contact a qualified technician.
Do not use extension leads, multiple sockets or adapters. Do
not connect the appliance to a socket which can be operated by
remote control.
12
Stampa la pagina