Jam D1200 Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Amplificatore Jam D1200. Jam D1200 6. Professional power amplifier

Stampa la pagina

SAFETY INSTRUCTIONS AND ADVICE

Warning! Please read this user manual fully before using this product, and make sure you

follow all the instructions, and heed all warnings.

Unpack the carton and check the contents to ensure all parts

are present and undamaged. Should there be any damage,

consult your dealer and do not use the equipment.

Retain the carton and packing materials if for any reasons the

equipment must be returned to the supplier. The carton and

internal packaging is designed to protect the equipment in

transit.

Do not open or modify the equipment.

The equipment should be used on a stable electrical supply

with supply voltage between 220V and 250V.

Intended for indoor use only, in a dry environment. This product

does not have an IP rating for outdoor use. If used outside the

equipment must be protected from water, and should be used

on an electrical supply with a suitable RCD.

Disconnect from the electrical supply when not in use, by

handling the plug only. Do not pull on the cable.

Do not switch off the equipment by twisting the blue power

connector. This connector is not load rated, and disconnecting

by this method may damage the contacts.

Before use, check the power cable is not damaged in any way.

If there are exposed inner cores, signs of burning, or any other

defects, you must replaced the power cable before user. Failure

to use a suitable power cable constitutes a fire and shock

hazard.

If the equipment is damaged in any way, or is subject to the

ingress of any fluids, immediately switch off the amplifier and

arrange to have it inspected by an engineer before operating

the equipment again.

10. Do not block any ventilation openings, and only use in a well

ventilated area so that excess heat can be dissipated away

from the equipment. Before each use, check the ventilation

openings at the front and fans at the rear are not obstructed in

any way, and are clear of dust, water or other contaminants. Do

not use in a closed cupboard or similar installation location.

11. Must be connected to an appropriate electrical outlet with a

protective ground connection. Only use an electrical cable with

the correct earth/ground pin. Check also the outlet has a

suitable current rating for the equipment. Failure to do so may

constitute a fire and shock hazard.

12. This equipment should only be used in a dry environment, and

should not be used where ingress of water or steam is possible

(such as swimming pool areas or kitchens) or where high

humidity could allow moisture inside of the amplifier.

13. Use the equipment at normal room temperature, and if used

outside, should be protected from direct sunlight to avoid

overheating of the equipment.

14. Volume controls should be set to zero before powering on the

unit, and then turned up as required to provide the required

level of sound whilst taking card to avoid damage to hearing.

15. Do not install near heat sources such as radiators or cooking

equipment that produces heat.

16. In the case of any abnormal operation being detected such as

excessiive heat, smoke, unusual odour, turn off the equipment

immediately, and if safe to do so, remove the power cord from

the electrical outlet. The unit should be inspected by an

engineer to check if repairs are required before further use of

the equipment.

17. To reduce the risk of electric shock, do not remove any covers.

There are no user-serviceable parts inside, and servicing must

be done by qualified personnel only.

18. This equipment has been tested and found to be

in compliance with the Electromagnetic

Compatability Regulations 2016, and has the

UKCA marking to demonstrate compliance.

19. This equipment has been tested and found to

be in compliance with EMC Directive:

2014/30/EU and LVD Directive: 2014/35/EU

and bears the CE Marking to demonstrate

compliance

20.

This equipment has been tested and conforms to current RoHS

requirements for the control of hazardous substances