Green Gorilla ProLine Manuale d'uso - Pagina 17

Sfoglia online o scarica il pdf Manuale d'uso per Spruzzatore di vernice Green Gorilla ProLine. Green Gorilla ProLine 20. Industrial system

Cleaning and Maintenance

1. If tank is pressurized, RELEASE AIR PRESSURE by depressing the red pin in the

Quick Connect Adaptor. ( gure 37) Push red pin in rmly and hold to allow all

pressure to escape.

2. Loosen manual pump slowly ( gure 35) and remove by rotating in the

counter-clockwise direction. (You may need to push down on the handle

slightly to unlock it.) Properly store any remaining spray solution per the

manufacturer's recommendation. Triple rinse all parts thoroughly with clean

water.

3. To ush the hose and wand, leave a small amount of clean water in tank,

pressurize and ush by depressing spray handle trigger for approximately 30

seconds. Release the pressure as outlined in step 1.

4. Drain the wand handle, extension, and hose by holding the wand handle

above the tank and depressing the trigger. This will allow all trapped water to

drain back into the depressurized tank.

5. Clean the spray wand's nozzle ori ces using a small cleaning brush set.

6. Always store tank indoors and empty and with the manual pump loose. If the

tank is to be stored outdoors, during freezing temperatures, the tank and

wand should be ushed with RV/Marine Anti-freeze to prevent equipment

damage.

7. If Quick Connect Adaptor pressure relief valve ( gure 37) is dirty, clean with

fresh water.

IMPORTANT! Do no store tank under pressure for extended periods.

Pg. 16