ENGLISH
Safety instructions
Installation
Warning! Only a qualified person can
install this appliance.
•
Remove all the packaging and the transit bolts.
•
Do not install or use a damaged appliance.
•
Follow the installation instruction supplied
with the appliance.
•
Always take care when moving the
appliance as it is heavy. Always use safety
gloves and enclosed footwear.
•
Make sure the air can circulate around the
appliance.
•
Do not tilt the refrigerator for more than 45°
form upright during moving it.
•
Wait at least 4 hours before connecting
the appliance to the power cord. This is to
allow the oil to flow back in the compressor.
This is needed also when performing door
reversibility and appliance is lying down.
•
Do not install the appliance close to
radiators or cookers, oven or hobs.
•
The rear of the appliance must stand
against the wall.
•
Do not install the appliance where there is
direct sunlight.
•
Do not install this appliance in areas that
are too humid or too colds, such as the
construction appendices, garages or wine
cellars.
•
When you move the appliance, lift it by the
front edge to avoid scratching the floor.
Electrical connection
Warning! Risk of fire and electrical shock.
Warning! When positioning the appliance,
ensure the supply cord is not trapped or
damaged.
Warning! Do not use multi-plug adapters
and extension cables.
•
The appliance must be earthed.
•
All electrical connections should be made by
a qualified electrician.
•
Make sure that the parameters on the rating
plate are compatible with the electrical
ratings of the mains power cord. If not,
contact an electrician.
•
Always use a correctly installed shockproof
socket.
•
Make sure not to cause damage to the
electrical components (e.g. power cord,
compressor). Contact the Authorised Service
Centre or an electrician to change the
electrical components.
•
The mains cable must stay below the level of
the mains plug.
•
Connect the power cord to the mains socket
only at the end of the installation. Make sure
that there is access to the power cord after
the installation.
•
Do not pull the power cord to disconnect the
appliance. Always pull the power cord.
Use
Warning! Risk of injury, burns, electrical
shock or fire.
The appliance contains flammable gas,
isobutane (R600a), a natural gas with a high
level of environmental compatibility. Be careful
not to cause damage to the refrigerant circuit
containing isobutane.
•
The surface of the compressor may become
hot under normal operation. Do not touch it
with hands.
•
Do not change the specification of this
appliance.
•
Do not put electrical appliances (e.g. ice
cream makers) in the appliance unless they
are stated applicable by the manufacturer.
•
If damage occurs to the refrigerant circuit,
make sure that there are no flames and
sources of ignition in the room. Ventilate the
room.
•
Do not let hot items to touch the plastic
parts of the appliance.
•
Do not store flammable gas and liquid in the
appliance.
•
Do not put flammable products or items
that are wet with flammable products in,
near or on the appliance.
•
Do not touch the condenser. They are hot.
7
Stampa la pagina