IKEA VINTERKALL Manuale - Pagina 21

Sfoglia online o scarica il pdf Manuale per Frigorifero IKEA VINTERKALL. IKEA VINTERKALL 48. Refrigerator - freezer
Anche per IKEA VINTERKALL: Manuale (28 pagine), Manuale (28 pagine), Manuale (13 pagine)

Stampa la pagina

ENGLISH

Problem

There is too much condensed

water on the rear wall of the

refrigerator.

Water flows inside the

refrigerator.

Water flows on the floor.

The door does not close

completely.

Error code explanation

E1: Temperature sensor failure of the

refrigerator chamber

E2: Temperature sensor failure of the freezer

chamber

E4: Defrosting sensor failure of the refrigerator

chamber

E5: Defrosting sensor failure of the freezer

chamber

E6: Communication failure

E7: Failure of ambient temperature sensor

EH: Humidity sensor failure

If your appliance still is not working

properly after making the above checks,

contact the Authorised Service Centre. You

can find the list at the end of this manual.

Possible Cause

Door was opened too frequently.

Door was not closed completely.

Stored food was not wrapped.

The drain hole at the back of the

appliance is clogged.

Food products prevent water from

flowing into the water collector.

The door is not closed well.

The appliance tilts forward.

The drip pan cracks.

The defrost water drain is clogged.

The shelves are out of position.

The door gaskets are dirty.

The appliance is not level.

Closing the door

3. If necessary, replace the defective door

Replacing the lamp

The appliance is equipped with a lamp for

interior lighting.

Only service is allowed to replace the lighting

device. Contact your Authorised Service Centre.

For quick solution, always refer to the full list

of Authorised Service Centre located at the

end of this manual and call your relative phone

number.

Open the door only when

necessary.

Make sure the door is closed

completely.

Wrap food in suitable packaging

before storing it in the appliance.

Clean the drain hole with a piece

of wire.

Make sure that food products do

not touch the rear plate.

Refer to "Closing the door", or

refer to the troubleshooting item

below ("The door does not close

completely").

Tilt the appliance slightly backward

(a quarter-inch lower in the back).

Refer to the separate Assembly

Instructions for appliance level

adjustment.

Contact Authorised Service Centre

listed at the end of this manual.

Clean the drain hole with a piece

of wire.

Make sure the shelves are in

correct position. Refer to "Movable

shelves".

Clean the door gaskets.

Refer to "Levelling feet", or the

separate Assembly Instructions.

Clean the door gaskets.

If necessary, adjust the door. Refer to the

separate Assembly Instructions.

gaskets. Contact the After Sales Service.

Solution