IKEA LIVSLAGA Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Piano cottura IKEA LIVSLAGA. IKEA LIVSLAGA 40. Burner
Anche per IKEA LIVSLAGA: Manuale d'uso (24 pagine), Manuale di istruzioni per il montaggio (20 pagine), Manuale d'uso (20 pagine)

Stampa la pagina

ENGLISH

Make sure that the outlet is near the product

to install. So, if the cable that came with the

product is not long enough, you will need to

replace it with another one having the same

features but with the right length.

Adjustment to different type of gas

WARNING

This operation must be performed by a

qualified technician.

If the appliance is intended to operate with

a different gas from the gas type stated on

the rating plate and information label on

the top of the hob, change the injectors.

Remove the information label and keep it

with the instructions booklet.

Use pressure regulators suitable for the gas

pressure indicated in the Instruction.

The gas nozzles must be changed

by After Sales Service or a qualified

technician.

Nozzles not supplied with the appliance

must be ordered from After Sales

Service.

Adjust the minimum setting of the taps.

NOTE: when liquid petroleum gas is used

(G30/G31), the minimum gas setting screw

must be tightened as far as it will go.

IMPORTANT: should you experience

difficulty in turning the burners knobs,

please contact the After Sales Service for

the replacement of the burner tap if found to

be faulty.

Replacing the injectors (see paragraph

"injector table")

Remove grids (A).

Extract burners (B).

Using a socket spanner of the

appropriate size unscrew the injector

(C), unscrew the injector to be replaced.

Replace it with the injector suitable for

the new type of gas.

Re-assemble the injector in (D).

Before installing the hob, remember to affix

the gas calibration plate supplied with

the injectors in such a way that it covers

the existing information relating to gas

calibration.

Adjusting minimum gas setting of taps

To ensure that the minimum setting is

correctly adjusted, remove the knob (E) and

proceed as follows:

tighten screw to reduce the flame height

(-);