ENGLISH
Contents
Safety information
For your safety and correct operation of the
appliance, read this manual carefully before
installation and use. Always keep these
instructions with the appliance even if you move
or sell it. Users must fully know the operation and
safety features of the appliance.
Recommendations and suggestions
• The manufacturer will not be held liable for
any damages resulting from incorrect or
improper installation.
• The minimum safety distance between the
cooker top and the extractor hood is: for elec-
trical hob 500mm and for gas hob 650mm.
• If the instructions for installation for the gas
hob specify a greater distance, this must be
respected.
• Check that the mains voltage corresponds to
that indicated on the rating plate fixed to the
inside of the hood.
• For Class I appliances, check that the
domestic power supply guarantees
adequate earthing.
• Connect the extractor to the exhaust flue
through a pipe of minimum diameter 120
mm. The route of the flue must be as short as
possible.
• Do not connect the extractor hood to exhaust
ducts carrying combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in conjunction with
non-electrical appliances (e.g. gas burning
appliances), a sufficient degree of aeration
must be guaranteed in the room in order to
prevent the backflow of exhaust gas. When
the cooker hood is used in conjunction with
appliances supplied with energy other than
4
5
6
7
electric, the negative pressure in the room must
not exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker hood.
• If the supply cord is damaged, it must be
replaced from the manufacturer or its service
agent.
• Connect the plug to a socket complying with
current regulations, located in an accessible
place.With regards to the technical and
safety measures to be adopted for fume
discharging it is importat to closely follow the
regulations provided by the local authorities.
• WARNING: Before installing the Hood,
remove the protective films (white and trans-
parent).
• Connect the hood to the power net by using
a bipolar switch having a contact gap of at
least 3 mm.
Use
• The extractor hood has been designed
exclusively for domestic use to eliminate
kitchen smells.
• Never use the hood for purposes other than
for which it has been designed.
• Never leave high naked flames under the
hood when it is in operation.
• Adjust the flame intensity to direct it onto the
bottom of the pan only, making sure that it
does not engulf the sides.
• Deep fat fryers must be continuously
monitored during use: overheated oil can
burst into flames.
• Do not flambè under the range hood; risk of
fire.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
4
8
9
10
10
Stampa la pagina