IKEA MATMASSIG Manuale - Pagina 17

Sfoglia online o scarica il pdf Manuale per Piano cottura IKEA MATMASSIG. IKEA MATMASSIG 28.
Anche per IKEA MATMASSIG: Manuale (24 pagine), Manuale (44 pagine), Manuale (44 pagine), Manuale (28 pagine), Manuale (48 pagine), Manuale (36 pagine), Manuale (28 pagine), Manuale (44 pagine), Manuale (29 pagine), Manuale (12 pagine), Manuale (48 pagine)

Stampa la pagina

ENGLISH

Electrical Requirements

You can check the parameters of

adjustment setting for this

appliance on the rating plate.

Refer to the Technical data

chapter.

The manufacturer declines any

liability if these safety measures

are not observed.

The appliance must be connected to a

220-240 V 50/60 Hz AC electrical supply.

Before activating the appliance, make sure

the electrical supply voltage is the same as

that indicated on the rating plate. The

rating plate is located below the surface of

the casing.

The appliance is supplied with a standard

7.5 amp service cord terminated by a 3-pin

plug for connection to a standard

household socket.

You must install the plug. The wires in the

mains lead are coloured in accordance with

the following code:

Green and yellow - Earth

Blue - Neutral

Brown - Live

1. Connect the green and yellow (earth)

wire to the terminal in the plug which is

marked with the letter 'E' or the earth

symbol

, or coloured green and

yellow.

2. Connect the blue (neutral) wire to the

terminal in the plug which is marked

with the letter 'N' or coloured black.

3. Connect the brown (live) wire to the

terminal in the plug which is marked

with the letter 'L' or coloured red.

There must be no cut or stray strands of

wire present. The cord clamp must be

correctly attached on the outer sheath.

DANGER

220-240 volts AC

Disconnect from

supply before

removing panel

knob

ignition

switches

To prevent contact between the

cable and the appliance below

the hob use the clamps which are

on the side of the cabinet.

Replacement of the connection cable

Warning! To replace the

connection cable, the technician

must have a specific equipment.

In this case, only cable type H05SS-F T180

must be used. The cable section must be

suitable to the voltage and the working

temperature. The yellow and green earth

wire

must be approximately 2 cm longer

than the brown or black phase wire

body

220-240V

ignition box

to burner spark plugs