IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 12

Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso e manutenzione per Cappa di ventilazione IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD. IKEA 30" (76.2 CM) WALL-MOUNT CANOPYRANGE HOOD 44. 30" (76.2 cm) wall-mount canopy range hood

Stampa la pagina

IMPORTANT: Clean the hood and grease filters frequently

according to the following instructions. Replace grease filters

before operating hood.

Exterior Surfaces:

To avoid damage to the exterior surface, do not use steel wool or

soap-filled scouring pads.

Always wipe dry to avoid water marks.

Cleaning Method:

Liquid detergent soap and water, or all-purpose cleanser

Wipe with damp soft cloth or nonabrasive sponge, then rinse

with clean water and wipe dry.

Metal Grease Filter:

1. Remove the filter by pulling the spring release handle and

then pulling down the filter.

A. Spring release handle

2. Wash metal filters as needed in dishwasher or hot detergent

solution.

3. Reinstall the filter by making sure the spring release handles

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

Non-Vented (recirculating) Installation Filters:

The charcoal filter is not washable. It should last up to 6 months

with normal use. Replace with Charcoal Filter Kit Number

W10412939.

To replace charcoal filter:

1. Remove metal grease filter from range hood. See "Metal

Grease Filter" in this section.

2. Bend spring clips away from metal grease filter.

3. Place charcoal filter into top side of metal filter.

RANGE HOOD CARE

Cleaning

4. Bend spring clips back into place to secure the charcoal filter

5. Replace metal grease filter. See "Metal Grease Filter" in this

Replacing a Lamp

Turn off the range hood and allow the lamp to cool. To avoid

damage or decreasing the life of the new bulb, do not touch bulb

with bare fingers. Replace bulb, using tissue or wearing cotton

gloves to handle bulb.

If new lamps do not operate, make sure the lamps are inserted

correctly before calling service.

1. Disconnect power.

2. Use a Phillips screwdriver to remove screw from lamp cover.

3. Remove lamp cover and set lamp cover and the screw aside.

4. Remove bulb and replace with a new 120 volt, 40 watt

5. Replace lamp cover and reinstall screw.

6. Reconnect power.

to the metal filter.

section.

maximum E-12 bulb.