IKEA IHW6302YB0 Istruzioni per l'installazione e manuale d'uso e manutenzione - Pagina 9
Sfoglia online o scarica il pdf Istruzioni per l'installazione e manuale d'uso e manutenzione per Cappa di ventilazione IKEA IHW6302YB0. IKEA IHW6302YB0 44. 30"(76.2cm) wall-mount canopy
Stampa la pagina
1.
Using 2 or more people, hang range hood on 2 mounting
screws through the mounting slots on back of hood.
A
I
For non-vented (recirculating) installation only:
1. Assemble the air deflector with the duct cover bracket with
2 - assembly screws provided.
C
C
A. Mounting screws
B. Mounting slots
C. Lower mounting screws
2. Remove the grease filter. See "Range Hood Care" section.
3. Level the range hood and tighten upper mounting screws.
4. Install 2 - 5 x 45 mm lower mounting screws and tighten.
1.
Connec
_nl __ _f , _;_,,_,
<__'_ _ "__*_
Install transition on top of hood (if removed for shipping) with
2 - 3.5 x 9.5 mm sheet metal screws.
A. Vent transition
B. 3.5 x 9.5 mm screw
For vented installations only:
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that back draft dampers work properly.
2.
3.
4.
5.
6.
7.
8.
A. Ventcover bracket
B. 2.9 x 6.5 mm screws
C. Deflector
Measure from the bottom of the air deflector to the bottom of
the hood outlet.
--
A
:..............
.........
J
A. Air deflector
B. Vent clamp
C. X = length to cut vent duct
D. Vent duct
E. Exhaust outlet
Cut the duct to the measured
size (×).
Remove
the air deflector.
Slide the duct onto the bottom
of the air deflector.
Place the assembled
air deflector
and duct over the exhaust
outlet from the hood.
Reassemble
the air deflector
to the duct cover bracket
with
2 assembly
screws.
Seal connections
with vent clamps.