Ganz ZC-DW4039 PHA Manuale operativo - Pagina 4

Sfoglia online o scarica il pdf Manuale operativo per Telecamera di sicurezza Ganz ZC-DW4039 PHA. Ganz ZC-DW4039 PHA 4. Wide dynamic range

Installing the dome enclosure

1. Remove the dome cover and the camera linear

Gently turn the dome cover counter-clockwise to unlock and pull free of the dome base. Remove the

camera linear by gently pulling it free of the two notches (D4) in the camera base (see fig. D)

2. Use the template to mark and prepare the mounting area

This installation sheet is designed to maintain the IP and NEMA rating independent of the chosen

installation method. Therefore, all mounting access positions are sealed until they are ready to be

used. When mounting the dome to a ceiling or wall using screws, use the template to cut a hole as

the circle marked"T5" with a hole cutter.

3. Open the required knock-out panel

Use a sharp knife or side cutter pliers to cut one of the side knock-outs (C3) to the size required to

allow cable insertion. Be careful not to hurt yourself or damage the camera when using knives and

side cutter pliers.

4. Mount the dome enclosure

Using one of the mounting schemes discussed overleaf (Methods for mounting the enclosure), fix

the dome enclosure in place.

5. Connect the connecters

All wires have been connected to the circuit board sealed

on the dome base.

When the enclosure is mounted

securely to a surface, connect your video out and power

in the cables to the G1 and G2 connectors.

A service jack socket is also provided for temporary video

connection when focusing the camera, using an optional

Service jack socket.

Important: Use only a Class 2 certified power supply.

6. Adjust the camera position

You can adjust the focusing position by rotating and

panning the camera base (see fig. E)

7. Install the camera liner

Carefully fit the camera linear (F1) over the camera base so that it snaps into place as shown in fig F

and does not obstructed the camera lens.

8. Replace the dome cover

Replace the dome cover (F2) and rotate to close it as shown in fig.F. Use the supplied T2 screw to

secure the whole enclosure (see fig. G)

9. Install the Quick Mount Kit (optional) (see fig.H)

a. Use the screws to adjust the position of the two locking arms on the Quick Mount adapter.

b. Thread cables through the Quick Mount adapter (H1) and install it onto the dome enclosure.

c. Attach Camera to Quick Mount Install Adapter using the thread.