Avantco 178SSUC48FHC Manuale d'uso - Pagina 10
Sfoglia online o scarica il pdf Manuale d'uso per Frigorifero Avantco 178SSUC48FHC. Avantco 178SSUC48FHC 10. Undercounter & worktop refrigerators & freezers
Anche per Avantco 178SSUC48FHC: Manuale d'uso (10 pagine)
Stampa la pagina
Troubleshooting
Problem
Compressor
not running.
Condensing units run for
long periods of time.
Cabinet temperature is
too warm.
Condensation is
collecting on the cabinet
and/or floor.
www.AvantcoRefrigeration.com
10
User Manual
Undercounter & Worktop Refrigerators & Freezers
Possible Cause
Fuse blown or circuit breaker tripped.
Power cord unplugged.
Thermostat set too high.
Cabinet in defrost cycle.
Excessive amount of water product in
cabinet.
Prolonged door opening or door ajar.
Door gasket(s) not sealing properly.
Dirty condenser coil.
Evaporator coil iced over.
Thermostat set too warm.
Airflow blocked.
Excessive amount of warm product
placed in cabinet.
Fuse blown or circuit breaker tripped.
Dirty condenser coil.
Evaporator coil iced over.
Low refrigerant levels.
Door is slightly ajar.
Gasket is not sealing properly.
Relative humidity is above 60%.
Possible Solution
Replace fuse or reset circuit breaker.
Plug in power cord.
Set thermostat to lower temperature.
Wait for defrost cycle to finish.
Allow adequate time for product to cool down.
Ensure doors are closed when not in use. Avoid
opening the doors for long periods of time.
Ensure gasket(s) are snapped in completely. Remove
gasket and wash with soap and water. Check
condition of gasket and replace if necessary.
Clean the condenser coil.
Unplug unit and allow coil to defrost. Make sure
thermostat is not set too cold. Ensure that door
gasket(s) are sealing properly.
Set thermostat to lower temperature.
Re-arrange product to allow for proper air flow. Make
sure there is at least 4" of clearance from evaporator.
Allow adequate time for product to cool down.
Replace fuse or reset circuit breaker.
Clean the condenser coil.
Ensure doors are closed when not in use. Avoid
opening doors for long periods of time.
Contact a service technician to check refrigerant
levels.
Make sure door is completely closed.
Clean, repair, or replace the gasket as necessary.
Move unit to area below relative humidity or lower
humidity level.