KitchenAid Briva Manuale di istruzioni per l'installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie KitchenAid Briva. KitchenAid Briva 6. In-sink dishwasher

Stampa la pagina

Electrical requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3-prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions

can result in death, fire, or electrical

shock.

If codes permit and a separate ground

wire is used, it is recommended that

a qualified electrician determine that

the ground path is adequate.

Do Not ground to a gas pipe.

Check with a qualified electrician if

you are not sure the dishwasher is

properly grounded.

Do Not have a fuse in the neutral or

ground circuit.

A 120-volt, 60-Hz, AC-only, 15- or

20-ampere fused electrical supply is

required. (Circuit breaker or time-

delay fuse is recommended.) It is

recommended that a separate circuit

serving only this appliance be

provided.

Hot Water Accessory Tank

If you plan to install the Hot Water

Accessory Tank Part No. 4396282, an

additional separate120-volt, 60-Hz, AC-

only, 15 or 20-ampere fused electrical

supply is required.

Garbage Disposer

If you plan to install garbage disposer,

an additional separate 120-volt, 60-Hz,

AC-only, 15 or 20-ampere fused

electrical supply is required.

Recommended

ground method

For your personal safety, this

appliance must be grounded. This

appliance is equipped with a power

supply cord having 3-prong ground

plug. To minimize possible shock

hazard, the cord must be plugged into

a mating 3-prong ground-type outlet,

grounded in accordance with local

codes and ordinances. See Figure 1.

If a mating outlet is not available, it is

the personal responsibility and

obligation of the customer to have a

properly grounded 3-prong outlet

installed by a qualified electrician.

3-prong

ground-type

3-prong

outlet

ground

plug

ground

prong

power

Figure 1

supply

cord

If dishwasher must

be direct wired

• Use flexible, armored or non-

metallic sheathed, copper wire with

grounding wire that meets the

wiring requirements for your home

and local codes and ordinances.

• Use a U.L.-listed conduit connector

or if using non-metallic sheathed,

copper wire, a U.L.-listed cable

clamp connector.

Water

requirements

For dishwasher:

• Hot water line with 20-120 psi water

pressure.

120°F water at dishwasher.

• Copper tubing with compression

fitting. 3/8" O.D. is recommended .

• A 90° elbow with 3/8" N.P.T. external

pipe threads on one end.

Important: Do not solder within 6"

from water inlet valve.

For sink faucet:

• Hot and cold water line.

• Copper tubing with compression

fittings for specific faucet to be

installed.

Drain

requirements

Separate drain P-traps for the sink and

dishwasher must be provided.

22-1/32"

to bottom of

dishwasher

drain

1/2"

minimum

Dishwasher drain:

If the dishwasher drain exits through

the back wall, the centerline of the

drain MUST be a minimum of 1/2"

below the dishwasher drain. This is

required to completely drain the

dishwasher tub so that no standing

water remains in tub.

back

wall