KitchenAid KD-21A SERIES Manuale di istruzioni per l'installazione - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie KitchenAid KD-21A SERIES. KitchenAid KD-21A SERIES 16.

Stampa la pagina

1. Before Starting

PLACING THE DISHWASHER IN ITS LOCATION

The adjustable kickboard and lower panel (Fig. 9) must be removed for access to dishwasher connections.

Remove

the kickboard (5) by removing the two screws (one with lock washer) that secure it. Remove two screws (1) and

pull out the bottom of lower panel to unhook tabs (2) from frame. Remove the lower panel by pulling it downward

to slide panel flanges (3) from behind the support channel (4).

Set the dishwasher

in front of the prepared cabinet opening and evenly.adjust

the four leveling feet to the desired

height.

Slide the dishwasher into the cabinet opening, being careful to avoid damage to the floor or interference with water,

drain, and electrical

lines. DO NOT remove the rear cross channel.

Rear cross channel

in alternate

position

Back of dishwasher

Step 3 -

Loosen

this screw

Step 2 -

Remove

this screw

( Step 4 -

Line up the lower cross

channel

hole with the

upper hole in frame.

Fasten securely

Tighten

the

screw at other end

STEP 1 -

Remove

these screws

Rear cross channel

in original

position

Fig.

Unlatch and open the door and remove the foam shipping cushions from upper corners of the door. Check to assure

that cabinet clearance

is equal on both sides of the dishwasher

and that cabinet interference

does not distort

dishwasher

tank.

With the door still open, place a spirit/bubble

level against the front tank flange (Fig. 11) and level the dishwasher

front-to-back

and side-to-side

by adjusting the leveling legs (Fig. 12) in or out as necessary.

'PL-loiio-1'

Fig.

If the dishwasher

is not properly leveled or if it is distorted by cabinet interference,

the door may not seal properly

and may leak. If necessary, the leveling leg may be further adjusted to correct any distortion and align tank for

equal clearance

on both sides (Fig. 12).

-9-