Decorelex F105SIX-LO Manuale d'uso - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso per Forno Decorelex F105SIX-LO. Decorelex F105SIX-LO 18. Built-in oven

Oven door structures 2 or 3

N. B :Installation in compliance with the consumption declaration

In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .Installing the oven

so that it rests on two strips of wood is preferable .If the oven rests on a continuous ,flat surface ,there must be an

aperture of at least 45×560mm .

The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer

exterior must be assembled with glues which can withstand temperatures of up to 100℃.

In compliance with current safety standards, contact with the electrical parts of the oven must not be possible

once it has been installed.

All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a tool.

To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into

the 4 holes located on the perimeter of the frame.

Electrical Installation

All model ovens on the front cover are dual rated, designed to be connected to

Either 208/240V AC ,60Hz,3 wire ,two-phase power supply.

Circuit Required

208V,60Hz

240V,60Hz

12AMP

15AMP

The electrical supply should be 3-wire two-phase AC. Install a suitable conduit box(not furnished). An

appropriately-sized, U-listed conduit connector must be used to correctly attach the conduit to the junction box.

Important:

Local Codes may vary; installation, electrical connections and grounding must comply with all

applicable local codes.

lf local codes permit grounding through the electrical supply neutral, connect both the white neutral wire and the

bare ground wire from the oven to the white neutral electrical supply wire.

Three-wire Connection

Page 16 of 17