KitchenAid KIDS36EPSS Manuale di istruzioni per l'installazione - Pagina 2

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie KitchenAid KIDS36EPSS. KitchenAid KIDS36EPSS 6. In-sink dishwasher

Stampa la pagina

Before you start...

Your safety and the safety of

others are very important.

We have provided many important

safety messages in this manual and

on your appliance. Always read and

obey all safety messages.

This is the safety alert symbol.

This symbol alerts you to

potential hazards that can kill

or hurt you and others. All safety

messages will follow the safety alert

symbol and either the word "DANGER"

or "WARNING". These words mean:

DANGER

You can be killed or seriously injured

if you don't immediately follow

instructions.

WARNING

You can be killed or seriously injured

if you don't follow instructions.

All safety messages will tell you what

the potential hazard is, tell you how to

reduce the chance of injury, and tell

you what can happen if the

instructions are not followed.

This dishwasher is manufactured for

inside use only.

Important: Observe all governing

codes and ordinances.

Proper installation is your responsibility:

•

Contact a qualified installer.

•

Installation must be performed by a

qualified service technician. The

dishwasher must be installed to all

electrical and plumbing national and

local codes and ordinances.

•

Install the dishwasher as specified in

these instructions.

•

Have everything you need to properly

install dishwasher.

Protect dishwasher and water lines

leading to dishwasher against freezing.

Damage from freezing is not covered by

the warranty.

The dishwasher is shipped ready for

installation of a one-hole faucet. If a two-,

three- or four-hole faucet is to be

installed, the holes must be added by a

qualified plumber according to the faucet

manufacturer's specifications.

If HOT WATER ACCESSORY TANK

Accessory Part No. 4396282 will be

used, the tank must be installed first.

the briva™ is not designed to be used

with any other small, "point of use"

water tank.

Tools and

materials needed:

• gloves (optional)

• safety glasses (optional)

• utility knife

• 5/8" open-end wrench (for water fill line

connection)

• 7/16" deep well socket (for

undercounter clamp brackets)

• Copper tubing with compression fitting

for water fill line (3/8" recommended).

Length needed is determined by specific

installation requirements.

• Copper tubing with compression fittings

for faucet connection. Length and

diameter needed are determined by

specific faucet installation requirements.

• small tubing cutter

• tape measure

• hacksaw

• flat bladed screwdriver

• faucet

• 2, 1-1/2" drain P traps

• 3-1/2" sink strainer

• plumber's putty

• sink strainer locknut wrench

• 10" adjustable wrench that opens to

1-1/8" (for 90° elbow)

• 90° elbow with 3/8" N.P .T. external

threads on one end. (The other end

must fit your water supply line.)

• Teflon

tape or pipe joint compound

• 1 cartridge silicone caulk and caulk gun

If using direct wiring:

• 1/4" hex nut driver

• 2 twist-on connectors of proper size to

connect house wiring to 16-gauge

dishwasher wiring.

• U.L.-listed cable clamp or conduit

connector to fit 7/8" inch hole

Additional tools may be required to cut

countertop and install drain lines. Follow

safety instructions for proper use of these

tools.

Parts supplied:

• undercounter clamp brackets

(adjustable for countertops 3/4" to

1-1/2" thick)

• cutting board