decorflame QC111 Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Stufa decorflame QC111. decorflame QC111 6. Electric stove heater

Stampa la pagina

After completely reading instructions, confirm

that all controls on stove are in the off position.

Plug the unit into a 15 amp, 120 volt outlet.

OPERATION

Controls and switches are located on front

panel inside the glass door.

FLAME: Press this button into the I position

for main power and flame effect. The indicator

light will turn on. See below for other control

switches.

HEATINg: For low heat function - Press this

switch while the FLAME switch is in the I

position for low heat. The indicator light will

turn on.

TURbO: For high heat function - Press

this switch while the FLAME and HEATINg

switches are in the I position for high heat. The

indicator light will turn on.

THERMOSTAT: To adjust the temperature to

your individual requirements. Turn the thermo-

stat dial to the right (clockwise) to increase the

desired temperature and to the left for lower

temperature. This thermostat control dial can

only be used while the FLAME switch and

HEATINg/TURbO switches are in the I position.

When the heater reaches the desired tempera-

ture, the heater and Heating /Turbo indicator

light will turn off but the fan will continue to

operate. Adjust this knob to restart the heater.

O P E R A T I O N

FLAME INTENSITY: Turn the dimmer dial

clockwise or counter clockwise to get the

desired flame intensity. The dimmer switch

can only be used when the FLAME switch is in

the I position.

NOTE: When the FLAME switch is turned in O

position, all other heater functions will stop

even though the switches may be in the I

position.

THERMOSTAT CONTROL

The heat output is controlled by the thermostat,

according to the room temperature. Set the

thermostat dial fully clockwise to the maxi-

mum position initially.

When the room is warm enough, reduce the

setting by slowly turning the thermostat dial

anticlockwise until the heater just clicks off.

This will then maintain the room temperature

at the desired level.

CAUTION

If you use this heater in conjunction with a

thermal control, a programme controller, a

timer or any other device that switches on the

heater automatically, remember to observe all

safety warnings at all times.

The stove heater has a safety overheat protec-

tion. If the overheat protection trips, turn off the

FLAME switch and unplug the power cord from

the receptacle. It should reset automatically

after 5 minutes.