IKEA MDB7749SAW0 Manuale di istruzioni per l'installazione - Pagina 24

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Lavastoviglie IKEA MDB7749SAW0. IKEA MDB7749SAW0 48. Undercounter dishwasher stainless steel tub

Stampa la pagina

Reconnect Power

Check ODe s ' on

•

Read the Dishwasher User Instructions that came with your

dishwasher.

Check that all parts have been installed and no steps were

skipped. Check that you have all tools used.

Start dishwasher and allow it to complete the shortest wash

cycle. After the first 2 minutes, unlatch door, wait 5 seconds,

then open door. Check that there is water in the bottom of the

dishwasher tub. Check that dishwasher is working properly.

If the dishwasher is not working properly, disconnect

power or

unplug dishwasher and see "If Dishwasher Does Not Operate"

section.

First try the solutions suggested here to possibly avoid the cost of

a service call.

•

Has the circuit breaker tripped or the house fuse blown?

•

Is the door closed tightly and latched?

•

Has the cycle been set correctly to start the dishwasher?

•

Is the water turned on?

If none of these possible solutions work, please see the Use and

Care Guide for service contact information.

Expect longer wash times. Your new dishwasher will average

2-3 hours per load, but use nearly 40% less energy than older

models. Designed with a low wattage, low energy consumption

motor, your dishwasher washes longer to ensure exceptional

cleaning. Certain models are equipped with an optical water

sensor so the first cycle will run longer to calibrate to optical

sensor. Selecting certain options could increase cycle time past

3.5 hours.

Rinse Aid is necessary for good drying results:

This dishwasher is designed to be used with rinse aid for good

drying performance and controlling buildup of hard water

deposits. Energy efficient dishwashers use less water and energy,

so they depend on the water sheeting action of rinse aid for good

drying performance.

Start/Resume light may flash:

When pressing Start/Resume, you must make sure the door is

closed within 3 seconds. If you do not close the door within

3 seconds, the Start/Resume light will flash until you press it

again. (You must also do this when adding a dish during the

middle of a cycle.)

NOTE: If a braided supply hose is used, replace inlet hose after

5 years to reduce the risk of hose failure. Record hose installation

or replacement dates on the hose for future reference.