ENGLISH
What to do if ...
In case your dishwasher doesn't work properly, check if the problem can be solved by going through the
following list. For other errors or issues please contact authorized After-sales Service which contact details can
be found in the warranty booklet. The manufacturer ensures the availability of spare parts for at least 10 years
after production date of this appliance.
Problems...
Salt indicator is lit
Rinse aid indicator is lit
The dishwasher won't start
or does not respond to
commands.
The dishwasher won't drain.
Display shows: 3 and
On/Off LED is blinking
rapidly
The dishwasher makes
excessive noise.
The dishes are not clean.
Possible causes...
Salt reservoir is empty. (After
refill the salt indicator may
remain lit for several wash
cycles).
Rinse aid dispenser is empty.
(After refill the rinse aid indicator
may remain lit for several wash
cycles).
The appliance has not been
plugged in properly.
Power outage.
The dishwasher door is not
closed.
Natural Dry pin is not pulled in.
It does not respond to
commands. Display shows: 9 or
12 and On/Off LED is blinking
rapidly.
The wash cycle has not finished
yet
The drain hose is bent.
The sink drain pipe is blocked.
The filter is clogged up with food
residues.
The dishes are rattling against
each.
An excessive amount of foam
has been produced.
The crockery has not been
arranged properly.
The spray arms cannot rotate
freely, being hindered by the
dishes.
The wash cycle is too gentle
and/or detergent efficiency is
low.
An excessive amount of foam
has been produced.
The cap on the rinse aid
compartment has not been shut
correctly.
The filter is soiled or clogged
There is no salt.
Solutions...
Refill reservoir with sal (for more information - see page 8).
Adjust water hardness - see table, page 8.
Refill dispenser with rinse aid (for more information - see
page 8).
Insert the plug into the socket.
For safety reasons, dishwasher will not re-start automatically
when power returns. Open dishwasher door, press Start
button and close the door within 4 seconds.
Vigorously push the door until you hear the "click".
Switch off the appliance by pressing the ON/OFF button,
switch it back on after approximately one minute and restart
the program. If problem persists, unplug the appliance for 1
minute, then plug it back in.
Wait until the wash cycle finishes
Check that the drain hose is not bent (see INSTALLATION).
Clean the sink drain pipe.
Clean the filter (see CLEANING THE FILTER ASSEMBLY).
Arrange the crockery correctly (see LOADING THE RACKS).
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers (see FILLING THE DETERGENT
DISPENSER). Restart the current cycle by switching OFF the
dishwasher, then switch it on again, select a new program,
press START/Pause and close the door within 4 seconds.
Please do not add any detergent.
Arrange the crockery correctly (see LOADING THE RACKS).
Arrange the crockery correctly (see LOADING THE RACKS).
Select an appropriate wash cycle (see PROGRAMS TABLE).
The detergent has not been measured out correctly or it is not
suitable
for use in dishwashers (see FILLING THE DETERGENT
DISPENSER).
Make sure the cap of the rinse aid dispenser is closed.
Clean the filter assembly (see CARE AND MAINTENANCE).
Fill the salt reservoir (see FILLING THE SALT RESERVOIR).
13
Stampa la pagina