Avantco MC49 Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Elettrodomestici da cucina Avantco MC49. Avantco MC49 6. Avantco cold wall evaporator milk coolers

User Manual

Please read this manual thoroughly prior to equipment set-up, operation and maintenance.

Inspection

When the equipment is received, all items should be carefully checked against the bill of landing

to insure all crates and cartons have been received. All units should be inspected for concealed

damage by uncrating the units immediately. If any damage is found, it should be reported to the

carrier at once, and a claim should be filed with the carrier. This equipment has been inspected and

tested in the Avantco Refrigeration. Facility and has been crated in accordance with transportation

rules and guidelines. Manufacturer is not responsible for freight loss or damage.

Installation

GENERAL

Take care when removing the skid, so that it will not damage the cooler's finish. Do not tip cabinet to

install casters or legs. Insure that the casters or legs are screwed all the way into the base.

LOCATION

The self contained refrigeration system located at the bottom of the cabinet requires free air access

for proper operation. The back of the cabinet may be positioned against a wall, however, there must

be a minimum four inch clearance between the sides and a wall. It is necessary to properly level

cooler to provide adequate drainage and efficient functioning of the unit.

ELECTRICAL

Check the proposed outlet to be used to insure that the voltage, phase, and current carrying

capacity of the circuit from the electrical panel correspond to the requirements of the cabinet. Plug

all standard models into a 110 volts A.C.60 cycle outlet. NEVER use an extension cord to power

any unit. All wiring between the electrical panel and the unit must be done in accordance with the

National Electric Code and all state and local codes. Refer to the Serial Tag for all pertinent electrical

information.

- 4 -