GAPOSA QC100 Manuale di istruzioni per l'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per l'uso per Unità di controllo GAPOSA QC100. GAPOSA QC100 16. Single-phase control unit

AUTOMATIC CLOSING MODE

The control includes, among its functions, the automatic closing after a

set time.

The automatic closing activates by programming the pause time and by

choosing the "impulse" operating mode (DIP 2 in OFF). When the dead-

man logic is active while closing, the automatic closing is excluded (DIP 2

in ON).

In order to program the pause time it is necessary:

1. To put DIP 5 and 6 in OFF

2. To put DIP 5 in ON. The green LED will switch off and make a short

flash every second.

3. Wait for the pause time you want to program (the time must be greater

than 5 seconds, for a maximum of 4 minutes)

4. After the required time replace the DIP 5 in OFF. If programming is

correct, the green LED will flash quickly and then remains lit.

ADDITIONAL NOTE: The time count for the automatic closing starts

when the opening movement is interrupted by the START/STOP

command or the intervention of the limit switch in opening; the

counting of the pause is notified via a short cut off of the green

LED every 3 seconds.

While in pause, a START/STOP control excludes the automatic

closing; a further START/STOP control closes the door. By pushing

the STOP control the automatic closing is excluded.

The automatic reclosure is excluded (even if programmed) if:

• a safety system intervenes (safety stop, photocell, bar, motor

thermal efficiency etc.)

• the dead-man logic is activated in closing

• a closing movement is interrupted.