Avantco 178SS1RGHC Manuale d'uso - Pagina 9

Sfoglia online o scarica il pdf Manuale d'uso per Congelatore Avantco 178SS1RGHC. Avantco 178SS1RGHC 9. Reach-in refrigerators and freezers
Anche per Avantco 178SS1RGHC: Manuale d'uso (8 pagine)

Stampa la pagina

Troubleshooting

Problem

Possible Cause

Fuse blown or circuit breaker tripped.

Power cord unplugged.

Compressor

not running.

Thermostat set too high.

Cabinet in defrost cycle.

Excessive amount of water product in

cabinet.

Prolonged door opening or door ajar.

Condensing units run for

Door gasket(s) not sealing properly.

long periods of time.

Dirty condenser coil.

Evaporator coil iced over.

Thermostat set too warm.

Airflow blocked.

Excessive amount of warm product

placed in cabinet.

Fuse blown or circuit breaker tripped.

Cabinet temperature is

too warm.

Dirty condenser coil.

Evaporator coil iced over.

Low refrigerant levels.

Door is slightly ajar.

Poor switch connection.

Interior light is not

Bulb is not connected.

working.

Bulb has burned out.

Gasket is not sealing properly.

Condensation is

collecting on the cabinet

and/or floor.

Relative humidity is above 60%.

User Manual

SS Series Reach-In Refrigerators and Freezers

Possible Solution

Replace fuse or reset circuit breaker.

Plug in power cord.

Set thermostat to lower temperature.

Wait for defrost cycle to finish.

Allow adequate time for product to cool down.

Ensure doors are closed when not in use. Avoid

opening the doors for long periods of time.

Ensure gasket(s) are snapped in completely. Remove

gasket and wash with soap and water. Check

condition of gasket and replace if necessary.

Clean the condenser coil.

Unplug unit and allow coil to defrost. Make sure

thermostat is not set too cold. Ensure that door

gasket(s) are sealing properly.

Set thermostat to lower temperature.

Re-arrange product to allow for proper air flow. Make

sure there is at least 4" of clearance from evaporator.

Allow adequate time for product to cool down.

Replace fuse or reset circuit breaker.

Clean the condenser coil.

Ensure doors are closed when not in use. Avoid

opening doors for long periods of time.

Contact a service technician to check refrigerant

levels.

Make sure door is completely closed.

Turn off light switch and turn it back on.

Make sure the bulb is correctly inserted in the

socket.

Replace the bulb.

Clean, repair, or replace the gasket as necessary.

Move unit to area below relative humidity or lower

humidity level.