Makita 1806B Manuale di istruzioni - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 1806B. Makita 1806B 13. Power planer
Anche per Makita 1806B: Manuale di istruzioni (17 pagine), Ripartizione delle parti (3 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (10 pagine), Manuale di istruzioni (11 pagine)
![Makita 1806B Manuale di istruzioni](/uploads/products/server2/2088699/2088699.jpg)
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of the
same
dimensions
oscillation/vibration will result, causing poor planing
action and, eventually, tool breakdown.
002561
There are two adjusting screws for each blade. When
installing the blade, the notch in the blade should fit over
the head of the adjusting screw. Then fit on the drum
cover and secure all the installation bolts only
finger-tight.
Turn the drum until the blade edge is right in the middle
between the front and rear bases.
Place the triangular rule flat on the rear base and run it
out over and across the blade edge. Turn the two
adjusting screws to adjust the blade protrusion. The
blade setting should be made so that the protrusion will
(A) Front base (Movable shoe)
(B) Rear base (Stationary shoe)
Correct setting
Nicks in surface
Gouging at start
Gouging at end
EN0004-1
and
weight,
or
1. Adjusting screw
1
2. Planer blade
2
3. Notch in the
blade
3
4. Drum cover
5. Drum
4
5
be uniform all the way across. Thus the triangular rule
should be flush with the entire width of the blade edge.
drum
After adjusting both blades, tighten all the installation
bolts evenly and alternately with the wrench.
002562
After tightening the bolts, secure the adjusting screws
fully.
For the correct planer blade setting
Your planing surface will end up rough and uneven,
unless the blade is set properly and securely. The blade
must be mounted so that the cutting edge is absolutely
level, that is, parallel to the surface of the rear base.
Refer to some examples below for proper and improper
settings.
(A)
(B)
(A)
(B)
(A)
(B)
6
1. Triangular rule
1
2. Screwdriver
2
Although this side view cannot
show it, the edges of the blades
run perfectly parallel to the rear
base surface.
Cause: One or both blades fails to
have edge parallel to rear
base line.
Cause: One or both blade edges
fails to protrude enough in
relation to rear base line.
Cause: One or both blade edges
protrudes too far in relation
to rear base line.