Makita 1911B Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 1911B. Makita 1911B 12. Power planer
Anche per Makita 1911B: Manuale di istruzioni (12 pagine), Manuale di istruzioni (16 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (18 pagine)

Stampa la pagina

For European countries only

When you wish to perform clean planing operation,

connect a Makita vacuum cleaner to your tool. Install the

nozzle on the tool using the screws. Then connect a hose

of the vacuum cleaner to the nozzle as shown in the

figures.

004951

OPERATION

Planing operation

001608

First, rest the tool front base flat upon the workpiece

surface without the blades making any contact. Switch

on and wait until the blades attain full speed. Then move

the tool gently forward. Apply pressure on the front of tool

at the start of planing, and at the back at the end of

planing. Planing will be easier if you incline the workpiece

in stationary fashion, so that you can plane somewhat

downhill.

The speed and depth of cut determine the kind of finish.

The power planer keeps cutting at a speed that will not

result in jamming by chips. For rough cutting, the depth of

cut can be increased, while for a good finish you should

reduce the depth of cut and advance the tool more

slowly.

1. Vacuum cleaner

1. Start

2. End

Chamfering

To make a cut as shown in the figure, align the ''V''

groove in the front base with the edge of the workpiece

and plane it as shown in the figure.

001609

001614

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Never use gasoline, benzine, thinner, alcohol or the

•

like. Discoloration, deformation or cracks may

result.

Sharpening the planer blades

001610

Always keep your blades sharp for the best performance

possible. Use the sharpening holder to remove nicks and

produce a fine edge.

First, loosen the two wing nuts on the holder and insert

the blades (A) and (B), so that they contact the sides (C)

and (D). Then tighten the wing nuts.

1. Align the (Y)

groove with the

edge of the

workpiece

1. Sharpening

holder