Makita 3620 Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 3620. Makita 3620 17. Router
Anche per Makita 3620: Manuale di istruzioni (20 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (17 pagine), Manuale di istruzioni (18 pagine)

Stampa la pagina
Makita 3620 Manuale di istruzioni
2
1
001985

Straight guide

003259
The straight guide is effectively used for straight cuts
when chamfering or grooving.
To install the straight guide, insert the guide bars into the
holes in the tool base. Adjust the distance between the
bit and the straight guide. At the desired distance, tighten
the wing bolts to secure the straight guide in place.
1
3
2
003260
When cutting, move the tool with the straight guide flush
with the side of the workpiece.
If the distance (A) between the side of the workpiece and
the cutting position is too wide for the straight guide, or if
the side of the workpiece is not straight, the straight
guide cannot be used. In this case, firmly clamp a straight
board to the workpiece and use it as a guide against the
router base. Feed the tool in the direction of the arrow.
A
003261
1. Feed direction
3
2. Bit revolving
direction
3. Workpiece
4. Straight guide
4
1. Straight guide
2. Guide bar
3. Wing bolt

Templet guide (Accessory)

003262
The templet guide provides a sleeve through which the
bit passes, allowing use of the tool with templet patterns.
To install the templet guide, loosen the screws on the tool
base, insert the templet guide and then tighten the
screws.
1
003263
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
6
003695
NOTE:
The workpiece will be cut a slightly different size
•
from the templet. Allow for the distance (X)
between the bit and the outside of the templet guide.
The distance (X) can be calculated by using the
following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
7
1. Screw
2
2. Base plate
3. Templet guide
3
1. Bit
7
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside
diameter of the
templet guide
7. Templet guide