Makita 3620 Manuale di istruzioni - Pagina 8

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 3620. Makita 3620 17. Router
Anche per Makita 3620: Manuale di istruzioni (20 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (17 pagine), Manuale di istruzioni (18 pagine)

1. Hex nut

deep with an 8 mm (5/16") diameter bit or more than 5

mm (3/16") deep with a 20 mm (13/16") diameter bit,

make several passes with progressively deeper bit

settings.

Stopper block

The stopper block has three adjusting hex bolts which raise

or lower 0.8 mm (about 1/32") per turn. You can easily obtain

three different depths of cut using these adjusting hex bolts

without readjusting the stopper pole.

Adjust the lowest hex bolt to obtain the deepest depth of cut,

following the method of "Adjusting depth of cut". Adjust the

two remaining hex bolts to obtain shallower depths of cut.

The differences in height of these hex bolts are equal to the

differences in depths of cut.

To adjust the hex bolts, first loosen the hex nuts on the hex

bolts with the wrench and then turn the hex bolts. After

obtaining the desired position, tighten the hex nuts while

holding the hex bolts in that desired position. The stopper

block is also convenient for making three passes with pro-

gressively deeper bit settings when cutting deep grooves.

CAUTION:

•

When using a bit having total length of 60 mm (2 - 3/8")

or more, or edge length of 35 mm (1 - 3/8") or more, the

depth of cut cannot be adjusted as previously

mentioned. To adjust, proceed as follows:

Loosen the lock lever and carefully adjust bit protrusion

below the tool base to the desired depth of cut by

moving the tool body up or down. Then re-tighten the

lock lever to lock the tool body at that depth of cut. Keep

the tool body locked at this position during use. Since

the bit always protrudes from the tool base, be careful

when handling the tool.

Adjusting the lock lever

003255

The locked position of the lock lever is adjustable. To adjust

it, loosen the lock lever 3/4 turn and press the center of the

lock lever. The hex nut will come out. Set the hex nut to the

desired position and tighten the lock lever.