Makita 4131 Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4131. Makita 4131 12. Metal cutter
Anche per Makita 4131: Manuale di istruzioni (12 pagine), Manuale di istruzioni (14 pagine), Manuale di istruzioni (12 pagine), Manuale di istruzioni (12 pagine)

Stampa la pagina

Loosen the lever on the depth guide and move the base

up or down. At the desired depth of cut, secure the base

by tightening the lever.

CAUTION:

After adjusting the depth of cut, always tighten the

•

lever securely.

Sighting

005345

When cutting, align the A position on the front of the

base with your cutting line on the workpiece.

Switch action

CAUTION:

Before plugging in the tool, always check to see

•

that the switch trigger actuates properly and

returns to the "OFF" position when released.

005346

To prevent the switch trigger from being accidentally

pulled, a lock-off button is provided.

To start the tool, push in the lock-off button and pull the

switch trigger. Release the switch trigger to stop.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before carrying out any work on the

tool.

1. Cutting line

1. Switch trigger

2. Lock-off button

Installing or removing saw blade

005347

005348

CAUTION:

Use only the Makita wrench provided to install or

•

remove the blade. Failure to do so may result in

overtightening or insufficient tightening of the hex

bolt. This could cause serious injury to the

operator.

Do not touch the blade with your bare hand

•

immediately after cutting, it may be extremely hot

and could burn your skin. Put on pair of gloves

when removing a hot blade.

To remove the blade, first push and turn the knob which

secures the dust cover clockwise to the

remove the dust cover. Press the shaft lock so that the

blade cannot revolve and use the hex wrench to loosen

the hex bolt counterclockwise. Then remove the outer

flange and blade.

To install the blade, follow the removal procedure in

reverse. Always install the blade so that the arrow on the

blade points in the same direction as the arrow on the

blade case.

BE SURE TO TIGHTEN THE HEX BOLT SECURELY.

005349

1. Dust cover

2. Knob

1. Hex wrench

2. Shaft lock

symbol and

1. Hex socket head

bolt

2. Outer flange

3. Carbide-tipped

saw blade

4. Inner flange