Makita 4302C Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4302C. Makita 4302C 16. Electronic jig saw

Front flush cuts

Loosen the bolt on the back of the base

with the hex wrench, then slide the base

backwards. Check the contact between the

back edge of the blade and the roller, then

secure the bolt.

Plunge cutting

Starting

cut

a t

other than the edge of

the workpiece without first drilling

starting hole requires a "plunge cut". This

can be accomplished by tipping the tool

forward until the front end of the base

rests against the workpiece. Switch the tool

on and lower the back end of the

tool

slowly, gradually allowing the blade to saw

through the workpiece until the base i s

able to s i t flat on the workpiece. YOU may

then proceed forward with the cut in

normal manner.

If using a drill for a starting hole, bore a

hole over 12 mm (1/2") in diameter. Then

insert the blade in it and proceed.

Finishing edges

To trim edges or make dimensional adjust-

ments, run the blade lightly along the cut

edges.

For smoother cutting of plywood or other

workpieces with easily splintered surfaces,

transparent tape may be used over your

cutting line.