Makita 4303C Manuale di istruzioni - Pagina 10

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4303C. Makita 4303C 16. Electronic jig saw

Front flush cuts

Loosen the bolt on the back of the base

with the hex wrench, then slide the base

backwards. Check the contact between the

back edge of the blade and the roller, then

secure the bolt.

Plunge cutting

Starting a cut a t other than the edge of the

workpiece without first drilling a starting

hole requires a "plunge cut". This can be

accomplished by tipping the tool forward

until the front end of the base rests against

the workpiece. Switch the tool on and

lower the back end of the tool slowly,

gradually allowing the blade to saw through

the workpiece until the base i s able to s i t

flat on the workpiece. You may then pro-

ceed forward with the cut in a normal

manner.

If using

drill for a starting hole, bore a

hole over 12 mm (1/2") in diameter. Then

insert the blade in

and proceed.

Finishing edges

To trim edges or make dimensional adjust-

ments run the blade lightly along the cut

edges.

For smoother cutting of plywood or other

workpieces with easily splintered surfaces,

transparent tape may be used over your

cutting line.