Bernina Quilting Frame Manuale di istruzioni per il montaggio - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Macchina da cucire Bernina Quilting Frame. Bernina Quilting Frame 16.

Table

Supports

Fig. 4-1

4-3: Follow Step 4-1 and 4-2 for

the other (7) Table Supports.

Step 5: Table Surface Assembly

Parts Needed:

2- Table Surface*

*Note: If you are setting the frame up in Crib Size you only need (1) Table Surface.

5-1: Lay the plastic table approximately centered, with the textured surface side UP on the

Table Supports as shown in Fig. 5-1.

5-2: Repeat Step 5-1 so that both plastic Table Surfaces are laying centered on the table assembly.

Step 6: Track Runners Assembly

Parts Needed:

4- Track Runners

2- Track Couplers

8- M5 X 8mm SBHCS

20- M5 X 15mm SBHCS

Tool Required:

3mm Allen Wrench

Note: For crib assembly only do Steps 6-5

through 6-6.

6-1: Slide a Track Coupler half way into a Track Runner.

Step 4: Table Support Assembly

M5 X 8mm

SBHCS

Parts Needed:

Tools Required:

*Note: If you are setting the frame up in Crib size you will

only need to use (4) Table Supports and (8) M5 x 8mm SBHCS.

4-1: Take (1) of the Table Supports and place it on the lip of

the Track Support, as shown in Fig. 4-1.

4-2: Attach the Table Support to the frame by tightening an

M5 X 8mm SBHCS, from above, into each end of the support.

8- Table Supports*

16- M5 x 8mm SBHCS*

3mm Allen Wrench (Provided)

Fig. 5-1

Track

Runner

Table Surface

Track Coupler

Fig. 6-1

M5 X 8mm

SBHCS

Pg.7