Makita 4329 Manuale di istruzioni - Pagina 6
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4329. Makita 4329 13. Jig saw
Anche per Makita 4329: Manuale di istruzioni (13 pagine), Specifiche tecniche (2 pagine), Manuale di istruzioni (13 pagine), Informazioni tecniche (7 pagine), Manuale di istruzioni (13 pagine)
Stampa la pagina
Speed adjusting dial (For models
4327/4328/4329)
1
008167
The tool speed can be infinitely adjusted between 500
and 3,100 strokes per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 6; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
Workpiece to be cut
Wood
Mild steel
Stainless steel
Aluminum
Plastics
006583
CAUTION:
If the tool is operated continuously at low speeds
•
for a long time, the motor will get overloaded and
heated up.
The speed adjusting dial can be turned only as far
•
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
1. Speed adjusting
dial
Number on adjusting dial
5 - 6
3 - 6
3 - 4
3 - 6
1 - 4
Installing or removing saw blade
1
2
3
008083
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately
extremely hot and could burn your skin.
Always secure the blade firmly. Insufficient
•
tightening of the blade may cause blade breakage
or serious personal injury.
Use only B type blades. Using blades other than B
•
type blades causes insufficient tightening of the
blade, resulting in a serious personal injury.
To install the blade, loosen the bolt counterclockwise on
the blade holder with the hex wrench.
With the blade teeth facing forward, insert the blade into
the blade holder as far as it will go. Make sure that the
back edge of the blade fits into the roller. Then tighten
the bolt clockwise to secure the blade.
1
2
008084
To remove the blade, follow the installation procedure in
reverse.
NOTE:
Occasionally lubricate the roller.
•
6
1. Blade holder
2. Bolt
3. Hex wrench
after
operation;
they
1. Bolt
2. Blade
3. Roller
3
may
be