Makita 4350CT Informazioni tecniche - Pagina 6

Sfoglia online o scarica il pdf Informazioni tecniche per Utensile elettrico Makita 4350CT. Makita 4350CT 14. Jig saw
Anche per Makita 4350CT: Specifiche tecniche (2 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine)

epair

7. Install Stop ring E-3 to secure Pin 4 as illustrated in Fig. 15.

8. Check whether Slider can reciprocate on Linear guides smoothly.

Note: If Slider does not reciprocate smoothly, Linear guides may lean to the left or the right.

Try again to assemble Linear guides correctly.

Fig. 15

9. Lubricate the parts assembled in Gear housing cover. Refer to [1] Lubrication in page 2.

10. Align Slider to Needle bearing 407 on crank complete, and then assemble Gear housing cover section to Gear housing

as illustrated in Figs. 6 and 16.

Note: 1) Do not forget to assemble packing between Gear housing cover and Gear housing.

2) Be sure to set Safety wire in place before fixing Handles L and R.

3) Be sure to tighten Strain relief firmly with 4x18 Tapping screws before fitting Handles L and R.

Otherwise, It may pull Power supply cord out of the body.

Fig. 16

Linear guide

Slider

Pin 4

Rod

Needle bearing 407

Slider

Gear housing

cover

Stop ring E-3

Crank complete

Balance plate

Gear housing

P 6 / 14