Makita 4350CT Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4350CT. Makita 4350CT 13. Jig saw
Anche per Makita 4350CT: Specifiche tecniche (2 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Informazioni tecniche (14 pagine)

To remove the blade, open the tool opener to the posi-

tion shown in the figure. Pull the saw blade out toward

the base.

► 1 . Jig saw blade

NOTE:

•

Occasionally lubricate the roller.

Hex wrench storage

► 1 . Base 2. Hex wrench

When not in use, the hex wrench can be conveniently

stored.

CAUTION:

•

Hold the tool firmly with one hand on the main

handle when performing the tool. If necessary,

the front part of the tool may be supported by

the other hand.

•

Always hold the base flush with the workpiece.

Failure to do so may cause blade breakage,

resulting in a serious injury.

► 1 . Cutting line 2. Base

Turn the tool on and wait until the blade attains full

speed. Then rest the tool base flat on the workpiece

and gently move the tool forward along the previously

marked cutting line. When cutting curves, advance the

tool very slowly.

Bevel cutting

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before tilting the base.

With the base tilted, you can make bevel cuts at any

angle between 0° and 45° (left or right).

Loosen the bolt on the back of the base with the hex

wrench. Move the base so that the bolt is positioned in

the center of the bevel slot in the base.

► 1 . Base 2. Bolt 3. Hex wrench

7 ENGLISH