Makita 4350FCT Informazioni tecniche - Pagina 11

Sfoglia online o scarica il pdf Informazioni tecniche per Utensile elettrico Makita 4350FCT. Makita 4350FCT 14. Jig saw
Anche per Makita 4350FCT: Specifiche tecniche (2 pagine), Ripartizione delle parti (3 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine)

epair

[12] Assembling armature

Do not assemble the used self lock 6. Self lock 6 has to be replaced with the new one.

Note:

Pay attention to the assembling direction of Self lock 6 and Wave washer 6. (Fig. 37)

Magnet sleeve is installed to the armature shaft on commutator side for sensing the variation of rotating speed.

If it would be damaged, the electronic speed control does not work any more.

Press Magnet sleeve by hand carefully instead of arbor press while applying 1R026 to Self lock 6.

Fig. 37

Ball bearing 607LLB

Insulation washer

[13] Disassembling Lever 17 (for orbital action mode change)

1. With referring to the following section, Handles L and R, and Gear housing cover.

[4] Disassembling Handle section section in page 3

[5] Disassembling Gear housing cover section in page 4

2. Remove Stop ring E-5 from the shaft of Lever 17 with slotted screwdriver. (Fig. 38)

3. While aligning Lever 17 with indication III, pull it out from Gear housing. (Fig. 39)

Then, Cap 5 and Compression spring 3 are removed. (Fig. 40)

Fig. 38

Stop ring E-5

*Self lock

*Magnet sleeve

*Wave washer 6

Rubber ring 19

*It is not used for model 4350T.

Fig. 39

Align Lever 17 with indication III.

Fig. 40

Cap 5

Compression

spring 3

Lever 17

P 11 / 14