Makita 4351CT Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 4351CT. Makita 4351CT 13. Jig saw
Anche per Makita 4351CT: Specifiche tecniche (2 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (9 pagine), Informazioni tecniche (15 pagine)
![Makita 4351CT Manuale di istruzioni](/uploads/products/server2/2092939/2092939.png)
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the position
shown in the figure. Pull the saw blade out toward the base.
1
008009
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
008033
When not in use, the hex wrench can be conveniently stored.
OPERATION
CAUTION:
Hold the tool firmly with one hand on the switch
•
handle and the other hand on the front grip when
performing the tool.
Always hold the base flush with the workpiece.
•
Failure to do so may cause blade breakage,
resulting in a serious injury.
1
008034
Turn the tool on and wait until the blade attains full
speed. Then rest the tool base flat on the workpiece and
gently move the tool forward along the previously
marked cutting line. When cutting curves, advance the
tool very slowly.
1. Jig saw blade
1. Base
2. Hex wrench
1
2
1. Cutting line
2. Base
2
Bevel cutting
008035
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before tilting the base.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the bevel slot in the base.
1
2
008013
Tilt the base until the desired bevel angle is obtained.
The V-notch of the gear housing indicates the bevel
angle by graduations. Then tighten the bolt firmly to
secure the base.
1
4
5
008014
Front flush cuts
1
2
008015
7
1. Base
3
2. Bolt
3. Hex wrench
1. Graduation
2
3
2. Bevel slot
3. Base
4. Gear housing
5. V-notch
6. Bolt
6
1. Base
3
2. Bolt
3. Hex wrench