Makita 5090DW Manuale di istruzioni - Pagina 9
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 5090DW. Makita 5090DW 17. 85mm with fast charger
Anche per Makita 5090DW: Elenco delle parti (1 pagine)
Stampa la pagina
BATTERY
CAUTION: Always switch
off
the tool before insertion or removal of the battery cartridge.
Read the Safety Instructions for battery on pages 3 and 4.
Installing or Removing the Battery
To
1
2
To
1
2
remove the battery cartridge:
.
Pull out the set plate on the tool
.
Grasp both sides of the cartridge
while withdrawing it from the barrel.
insert the battery cartridge:
.
Align the tongue of the battery
cartridge with the groove in the
housing.
. Slip the cartridge into place.
3. Snap the set plate back into place. Be sure to close the set plate fully before
using the tool.
CAUTION: Do not use force when inserting the battery cartridge.
If the cartridge does not slide in easily, it is not being inserted correctly.
Charging the Battery
CAUTION: YOUR NEW BATTERY CARTRIDGE IS NOT CHARGED.
YOU WILL NEED TO CHARGE IT BEFORE USE.
Read Safety instructions on page 4 before charging battery.
To charge the battery:
1. Plug the fast charger into your
power source.
2. Insert the battery cartridge so that
the plus (+) and minus (-) terminals
on the battery cartridge are on the
same sides as their respective
markings on the fast charger.
3. Insert the cartridge fully into the port
so that
it rests on the charger port
floor.
4. Press the start button (red).
The charging light will come on and charging will begin.
(If the charging light does not come on, see NOTE on page 10).
5.
When the charging light goes out after about one hour, you may remove the
fully charged battery cartridge.
6.
After charging, unplug the charger
from
the power source. Charging
continued
9