Makita 9218SB Manuale di istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita 9218SB. Makita 9218SB 8. Disc sander
Anche per Makita 9218SB: Manuale di istruzioni (13 pagine), Ripartizione delle parti (2 pagine), Manuale di istruzioni (10 pagine)

Stampa la pagina

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before carrying out any work on the

tool.

Installing side grip (auxiliary handle)

003410

CAUTION:

Always be sure that the side grip is installed

•

securely before operation.

Screw the side grip on the tool securely.

Installing or removing abrasive disc

003414

Mount the rubber pad onto the spindle. Fit the abrasive

disc on the rubber pad and screw the lock nut onto the

spindle.

To tighten the lock nut, hold the spindle with the wrench

so that it cannot revolve, then use the lock nut wrench

and securely tighten clockwise.

003416

To remove the disc, follow the installation procedure in

reverse.

1. Side grip

1. Lock nut

2. Abrasive disc

3. Rubber pad

4. Spindle

1. Lock nut wrench

2. Wrench

OPERATION

Sanding operation

010320

CAUTION:

Always wear safety goggles or a face shield during

•

operation.

Never run the tool without the abrasive disc. You

•

may seriously damage the pad.

Hold the tool firmly with one hand on the gripping part of

the tool and the other hand on the side grip when

performing the tool. Turn the tool on and then apply the

abrasive disc to the workpiece.

In general, keep the abrasive disc at an angle of about

15 degrees to the workpiece surface. Apply slight

pressure only. Excessive pressure will result in poor

performance and premature wear to abrasive disc.

MAINTENANCE

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before attempting to perform inspection

or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly.

Replace when they wear down to the limit mark. Keep

the carbon brushes clean and free to slip in the holders.

Both carbon brushes should be replaced at the same

time. Use only identical carbon brushes.

Use a screwdriver to remove the brush holder caps.

Take out the worn carbon brushes, insert the new ones

and secure the brush holder caps.

1. Limit mark