Makita BJN161 Manuale di istruzioni - Pagina 7

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita BJN161. Makita BJN161 13. Cordless nibbler
Anche per Makita BJN161: Manuale di istruzioni (11 pagine), Informazioni tecniche (8 pagine), Manuale di istruzioni (13 pagine), Manuale di istruzioni (12 pagine)

Stampa la pagina
Makita BJN161 Manuale di istruzioni
Indication lamp with multi function
013277
Indication lamps are located in two positions.
Battery cartridge replacing signal
When the battery power is almost used up
during operation, the red lamp lights up and
the tool stops immediately. Replace the
battery with fully charged one when the red
lamp lights up.
Accidental re-start preventive function
Even if the battery cartridge is inserted on
the tool with the slide switch in the "I (ON)"
position, the tool does not start. At this time,
the lamp flickers slowly and this shows that
the accidental re-start preventive function is
at work.
To start the tool, first slide the slide switch
toward the "O (OFF)" position and then slide
it toward the "I (ON)" position.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Removing or installing the punch and die
1
2
3
004779
Always replace the punch and die as a set. To remove
the punch and die, loosen the lock nut with the wrench.
Remove the die holder from the tool. Use the hex
wrench to loosen the bolts which secure the die.
Remove the die from the die holder.
Use the hex wrench to loosen the screw which secures
the punch. Pull the punch out of the punch holder.
1. Indicating lamp
1
1. Die holder
2. Die
3. Bolts
4. Hex wrench
4
1
5
2
3
013274
To install the punch and die, insert the punch into the
punch holder so that the notch in the punch faces
toward the screw. Tighten the screw to secure the
punch. Install the die on the die holder. Tighten the bolts
to secure the die.
004781
Then install the die holder on the tool so that the punch
is inserted through the hole in the die holder. Tighten the
lock nut to secure the die holder. After replacing the
punch and die, lubricate them with machine oil and run
the tool for a while.
1
2
3
004782

OPERATION

Pre-lubrication
Coat the cutting line with machine oil to increase the
punch and die service life. This is particularly important
when cutting aluminum.
7
1. Punch
2. Punch holder
3. Screw
4. Hex wrench
6
5. Loosen
6. Tighten
4
1. Punch
2. Notch
1
2
1. Bolts
2. Die
4
3. Punch
4. Die holder