Makita BJV140 Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita BJV140. Makita BJV140 13. Cordless jig saw
Anche per Makita BJV140: Manuale di istruzioni (13 pagine), Manuale di istruzioni (13 pagine), Informazioni tecniche (13 pagine), Manuale di istruzioni (18 pagine)
Lighting up the lamps
CAUTION:
Do not look in the light or see the source of light
•
directly.
To turn on the lamp, pull the trigger. Release the trigger to
turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing saw blade
CAUTION:
Always clean out all chips or foreign matter
•
adhering to the blade and/or blade holder. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious personal injury.
Do not touch the blade or the workpiece
•
immediately after operation; they may be extremely
hot and could burn your skin.
Tighten the saw blade securely. Failure to do so
•
may cause a serious injury.
When you remove the saw blade, be careful not to
•
hurt your fingers with the top of the blade or the tips
of workpiece.
To install the blade, open the tool opener to the position
shown in the figure.
1
001909
Keeping that situation, insert the saw blade into the blade
clamp as far as the two protrusions of the blade can not
be seen.
1. Tool opener
7
3
1
2
001910
Return the tool opener to its original position.
After installing, always make sure that the blade is
securely held in place by trying to pull it out.
CAUTION:
Do not open the tool opener excessively, or it may
•
cause tool damage.
To remove the blade, open the tool opener to the position
shown in the figure. Pull the saw blade out toward the
base.
1
001911
NOTE:
Occasionally lubricate the roller.
•
Hex wrench storage
1
007486
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1. Blade clamp
2. Jig saw blade
3. Protrusions
1. Jig saw blade
1. Base
2. Hex wrench
2