Gardco PureForm P34 Manuale rapido di strat - Pagina 2

Sfoglia online o scarica il pdf Manuale rapido di strat per Luce per esterni Gardco PureForm P34. Gardco PureForm P34 3. Area luminaire

Pole with Tenon (See Table)

Open Arm Cover by loosening (2) #8-32 Phillips Pan Head Screws located on bottom of mounting arm (screws are captive and will re-

main on door). Door is attached to arm with a safety cable and can be removed if necessary. (See Fig. 1 & 2)

Attach luminaire/arm assembly to Pole Top Fitter by lining up the threaded hole on PTF to bottom hole on Arm.

Thread the bottom 3/8" bolt, lock washer, and flat washer into the lower tapped hole of the PTF from the inside of arm assembly and

tighten. (See Fig. 1,2 & 4)

Pass the top 3/8" bolt, lock washer, and flat washer through the arm and into the top hole of the PTF. Secure with 3/8" lock washer

and hex nut. Torque both bolts to approximately 45 FT.-LBS.

Install the Pole Top Fitter/Luminaire onto the Tenon. Top of the tenon must seat against the fitter stop. Level and secure with (8) 3/8"

socket set screws. Torque to approximately 20 FT.-LBS.

Install strain relief rod through two holes in top of fitter, and route supply and ground wires over the strain relief rod. Tie off with tape

or wire tie as shown.

Connect field supply and ground wires to luminaire leads. Make wire connections per NEC or applicable local codes. Secure with wire

tie.

Install PTF Cap and secure in place with (2) #10-32 Phillips Pan Head Screws.

Install Photo Control in housing if used.

10. Close Arm Assembly Cover and secure with

11. Apply a bead of suitable weatherproof sealant to horizontal top, vertical left and right edges of Arm where it contacts the pole to pre-

vent water entry. (See Figure 5)

12. Energize Luminaire to test installation.

1/29/2019

page 2

www.gardcolighting.com

PureForm & EcoForm Luminaire Mounted on PTF2 (3-1/2" O.D.),

PTF3 (4-1/2" O.D.) or PTF4 (5.00" O.D.) Pole Top Fitter

TENON HEIGHT

2) #8-32 Phillips Pan Head Screws.

(

PTF2

FITTER

"X"

TYPE

DIA. (Ø)

PTF2

3-1/2"

PTF3

4-1/2"

PTF4

FIG. 3

PTF3/PTF4

FIG. 4

USED ON TENON SIZE

2-3/8" TO 2-1/2" O.D. X 4" HIGH

3" TO 3-1/2" O.D. X 6" HIGH

3-1/2" TO 4" O.D. X 6" HIGH

PN 442294663261 Rev A