Avanti SBCA017G Manuale di istruzioni - Pagina 7
Sfoglia online o scarica il pdf Manuale di istruzioni per Frigorifero Avanti SBCA017G. Avanti SBCA017G 16. Superconductor refrigerator
Anche per Avanti SBCA017G: Elenco delle parti (2 pagine), Manuale di istruzioni (16 pagine), Manuale (4 pagine)
WARNING
Read all instructions before using the Beverage Cooler.
DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous . . . even if they will "just sit in the garage a few days".
Before you throw away your old Beverage Cooler: Take off the door. Leave the shelf in
place so that children may not easily climb inside.
Never allow children to operate, play with, or crawl inside the Beverage Cooler.
Never clean Beverage Cooler parts with flammable fluids. The fumes can create a fire hazard
or explosion.
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or
any other Beverage Cooler. The fumes can create a fire hazard or explosion.
Do not repair or replace any part of the Beverage Cooler or attempt any servicing unless
specifically recommended in the user-maintenance instructions or in published user-repair
instructions. Replace the fuse with the same type.
Before Using Your Beverage Cooler
Remove the exterior and interior packing.
Check to be sure you have all of the following parts:
2 Shelves
1 Instruction manual
Additional 2 keys(For model SBCA017GL only)
Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Beverage Cooler
This Beverage Cooler uses superconductor heat-pipe refrigeration technology (no
compressor).
This appliance is designed to be free standing only, and should not be recessed or built-in
(Fully recessed).
Place your Beverage Cooler on a floor that is strong enough to support the Beverage Cooler
when it is fully loaded.
Allow 5 inches of space between the back and sides of the Beverage Cooler, which allows
the proper air circulation to cool the heat sink.
Locate the Beverage Cooler away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Extreme cold ambient temperatures may also cause the Beverage
Cooler not to perform properly.
Avoid locating the Beverage Cooler in moist areas.
Plug the Beverage Cooler into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified electrician
or an authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing food in the Beverage Cooler compartment.
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, or injury
when using your Beverage Cooler, follow these
basic precautions:
-Save these instructions-
INSTALLATION INSTRUCTIONS
7