Makita DCG180 Manuale di istruzioni - Pagina 8
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita DCG180. Makita DCG180 12. Vezeték nélküli szigetelępisztoly
Anche per Makita DCG180: Manuale di istruzioni (12 pagine), Manuale di istruzioni (12 pagine), (Ungherese) Manuale d'uso Manuale d'uso (10 pagine)
Stampa la pagina
Installing holder
013561
013562
Hold the bottom of the holder and the holder joint, then
turn the holder clockwise. Tighten it firmly until it stops.
Make sure the holder is tightened firmly. Otherwise the
tool may be damaged.
To remove the holder, turn it counter clockwise.
NOTE:
You can rotate the holder in accordance with
•
required situations to facilitate the operation.
The short holder (300ml) is intended for the
•
cartridges only. Use only piston A with short holder
(300ml), and do not use it with film type packs or
direct
filling.
Also
accordance with the holder type.
Installing cartridge
NOTICE:
Make sure the piston A is attached to the rod. Do
•
not use other type of piston for cartridge.
Installing the cartridge into the short holder (300ml)
013566
Pull the rod handle backwards slowly until it stops.
use
appropriate
1. Rod handle
1
013567
Insert the cartridge into the holder as illustrated.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, pull the rod backwards until it
stops, then lift out the cartridge.
Installing the cartridge into the long holder (600ml)
1
013572
Remove the holder cap from the holder.
Pull the rod handle backwards slowly until it stops.
1
rod
in
013571
Insert the cartridge into the holder.
Attach the holder cap. Make sure it is tightened firmly.
Push the rod gently until the piston touches the bottom
of the cartridge.
To remove the cartridge, remove the holder cap, then
take out the cartridge.
NOTICE:
Always check the cartridge for puncture or
•
damage before installing. Do not use damaged
cartridge, otherwise the tool may be damaged.
When using a partially used cartridge, remove any
•
adhered material on the cartridge.
8
1. Holder cap
2. Rod handle
2
1. Holder cap