Makita DJV184RTJ Manuale di istruzioni - Pagina 12

Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita DJV184RTJ. Makita DJV184RTJ 17.

Plunge cutting

Fig.17

You need not bore a starting hole or make a lead-in cut

if you carefully do as follows.

Tilt the tool up on the front edge of the base with

the jig saw blade point positioned just above the work-

piece surface.

Apply pressure to the tool so that the front edge of

the base will not move when you switch on the tool and

gently lower the back end of the tool slowly.

As the jig saw blade pierces the workpiece, slowly

lower the base of the tool down onto the workpiece

surface.

Complete the cut in the normal manner.

Finishing edges

Fig.18

To trim edges or make dimensional adjustments, run the

jig saw blade lightly along the cut edges.

Always use a suitable coolant (cutting oil) when cutting

metal. Failure to do so will cause significant jig saw

blade wear. The underside of the workpiece can be

greased instead of using a coolant.

Installing or removing the dust cover

Optional accessory

Install the dust cover as shown in the figure.

Fig.19

► 1 . Dust cover

12 ENGLISH