Makita DJV184RTJ Manuale di istruzioni - Pagina 8
Sfoglia online o scarica il pdf Manuale di istruzioni per Utensile elettrico Makita DJV184RTJ. Makita DJV184RTJ 17.
Stampa la pagina
To change the cutting action, just turn the cutting action
changing lever to the desired cutting action position.
Refer to the table to select the appropriate cutting
action.
Position
Cutting action
0
Straight line cutting
action
I
Small orbital
cutting action
II
Medium orbital
cutting action
III
Large orbital
cutting action
Switch action
To turn on the tool, press the lock/unlock button. The
tool turns into the standby mode. To start the tool, pull
the switch trigger in the standby mode. Tool speed is
increased by increasing pressure on the switch trigger.
To stop the tool, release the switch trigger. The tool
turns into the standby mode. To turn off the tool, press
the lock/unlock button in the standby mode.
For continuous operation, pull the switch trigger in the
standby mode, and then push in the lock on button.
To stop the tool, pull the switch trigger fully, and then
release it.
1
Fig.4
► 1 . Lock/unlock button 2. Lock on button 3. Switch
trigger
NOTE: If the tool is left for 10 seconds without any
operation in the standby mode, the tool automatically
turns off and the lamp goes off.
NOTE: The lock/unlock button is not available while
the tool is operating.
Applications
For cutting mild
steel, stainless
steel and plastics.
For clean cuts in
wood and plywood.
For cutting mild
steel, aluminum
and hard wood.
For cutting wood
and plywood.
For fast cutting in
aluminum and mild
steel.
For fast cutting in
wood and plywood.
2
3
Lighting up the front lamp
CAUTION:
Do not look in the light or see the
source of light directly.
To turn on the lamp, press the lock/unlock button. To
turn off the lamp, press the lock/unlock button again.
1
Fig.5
► 1 . Lamp
NOTICE:
When the tool is overheated, the lamp
blinks. Cool down the tool fully before operating
the tool again.
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
Speed adjusting dial
Fig.6
► 1 . Speed adjusting dial
The tool speed can be adjusted by turning the speed adjusting dial.
You can get the highest speed at 5 and the lowest speed at 1.
Refer to the table to select the proper speed for the work-
piece to be cut. However, the appropriate speed may differ
with the type or thickness of the workpiece. In general,
higher speeds will allow you to cut workpieces faster but
the service life of the jig saw blade will be reduced.
Workpiece
Wood
Mild steel
Stainless steel
Aluminum
Plastics
8 ENGLISH
1
Number
4 - 5
3 - 5
3 - 4
3 - 5
1 - 4