GARDEN MASTER GM1511 Manuale di istruzioni per il montaggio - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto GARDEN MASTER GM1511. GARDEN MASTER GM1511 8. Sloping roof shed
Anche per GARDEN MASTER GM1511: Istruzioni per il montaggio (2 pagine)
Stampa la pagina
COMPONENTS CHECKLIST
Please check the parts carefully and advise immediately if any are damaged or missing.
2 x 1770mm sheets for the back
A
Door pre-hinged to 715mm sheet
D
with door jamb
2 x 1200mm 'L's for flashing the roof
G
to the side walls
1 x pack of rivets with padbolt for Zincalume
J
sheds, rivets for colour sheds, 2 x 'Z' door
braces and riveter for general assembly
IMPORTANT!
•
Remove the swarf (drill filings) from the panels as you assemble them.
•
All components are cut to length. Do not cut any parts unless instructed.
•
Rivets through the inside of the channels into the sheeting are just as important
as rivets from the outside.
RIBS AND PANS
•
Generally most rivets are spaced at 300mm apart.
•
Keep the rivets in the pans as close to the ribs as possible for added strength.
•
Ribs will always protrude to the outside of the shed.
•
Extra internal rivets are strongly recommended in high wind areas.
BUILDING YOUR SHED
The basic task is to join the sheets together to form your
panels, and rivet channels to the top and bottom of these
panels. They will then join together to form your shed
(diagram 1, 2 and 3).
!
2
2 full and 2 half 1830mm-1770mm
B
sloping sheets (side walls 1
4 x 1065mm channels for end walls
E
2 x 1515mm channels for the roof
2 x 793mm door spacers
H
If you choose to vary from these instructions your
warranty will be impaired.
left, 1
right)
1 / 2
1 / 2
DIAGRAM 1
DIAGRAM 2
i
If you need advice, call us
or email us at [email protected]
2 x 1200mm sheets for the roof
C
4 x 1515mm channels with ends cut
F
for front and back walls
1 x 'Z' door jamb attached to a channel
I
for the corner door jamb
Pan
DIAGRAM 3
FREE
on
0800 807 433
Rib