GARDEN MASTER GM2323 Manuale di istruzioni per il montaggio - Pagina 2
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto GARDEN MASTER GM2323. GARDEN MASTER GM2323 8. Gable roof shed
Stampa la pagina
COMPONENTS CHECKLIST
Please check the parts carefully and advise immediately if any are damaged or missing.
3 x 1830mm sheets for back
A
Door pre-hinged to 700mm
E
sheet with door jamb
4 x 1200mm 'L's for flashing
I
the roof to the end walls
2 x gable plates for
L
gable ends
IMPORTANT!
•
Remove the swarf (drill filings) from the panels as you assemble them.
•
All components are cut to length. Do not cut any parts unless instructed.
•
Rivets through the inside of the channels into the sheeting are just as important
as rivets from the outside.
RIBS AND PANS
•
Generally most rivets are spaced at 300mm apart.
•
Keep the rivets in the pans as close to the ribs as possible for added strength.
•
Ribs will always protrude to the outside of the shed.
•
Extra internal rivets are strongly recommended in high wind areas.
BUILDING YOUR SHED
The basic task is to join the sheets together to form your
panels, and rivet channels to the top and bottom of these
panels. They will then join together to form your shed
(diagram 1, 2 and 3).
!
2
6 x 1200mm sheets for roof
B
4 x 2255mm channels with
F
ends cut for front and
back walls
2 x 793mm door spacers
J
1 x pack of rivets with padbolt for Zincalume sheds, rivets for colour
M
sheds, 2 x 'Z' door braces and riveter for general assembly
If you choose to vary from these instructions your
warranty will be impaired.
4 x sloping sheets &
C
2 x gable cut sheets for ends
4 x 2255mm channels
G
for roof
1 x 2255 mm ridge beam
K
DIAGRAM 1
DIAGRAM 2
i
If you need advice, call us
or email us at [email protected]
1 x 780mm wide sheet with
D
door jamb attached
2 x 2255mm channels for
H
bottom & 2 x 2290mm
channels for top of end walls
2 x 'Z' door braces
N
Pan
DIAGRAM 3
FREE
on
0800 807 433
Rib