GARDEN MASTER GM3023 Manuale di istruzioni per il montaggio - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per il montaggio per Deposito all'aperto GARDEN MASTER GM3023. GARDEN MASTER GM3023 8. Gable roof shed
Anche per GARDEN MASTER GM3023: Istruzioni per il montaggio (2 pagine)
Stampa la pagina
STEP 3:
END WALLS
1.
Join 3
sheets together to create a gable end wall as shown.
C
2.
Cap the bottom of the sheets with an
3.
Cap the angled top of the sheets with a 2290mm channel. With tin snips make
a cut on the top and bottom of the channel at 1145mm (center) and then fold
channel to follow the angle of the sheeting.
4.
Slip the flat
gable plate between the channel and the sheeting on the
L
outside of the wall. Take the other
fold in it and slip it between the channel and the sheeting on the
underside of the wall. (this will be used to support the gable
roof strengthening section)
5.
Rivet the channels at every 2nd rib and through
the gable plate into the sheeting ribs.
6.
Drill and rivet 3 rivets to the underside
of the wall through the channel and
into the wall pan of the sheet.
7.
Perform the same again
for the other end.
WATCH OUR
SHED ASSEMBLY
VIDEO GUIDE
HERE
STEP 4:
DOOR BRACES
1.
The door braces can be riveted now or after you have
assembled your shed.
2.
Tuck one end of the 'Z' between the bottom channel of the
inside of the door and the sheet. Do the same at the top,
overlapping in the centre behind the padbolt.
If you have a locking 'T' handle you will have to run the
'Z's the opposite way to the diagram.
3.
Rivet the 'Z's at the ends, and in the centre of the channel
it is tucked under, and through the overlap in the centre.
Two or three more rivets will be required through the door
sheeting into the 'Z', but they will need to be riveted through
from the outside of the door for a neater appearance.
4.
You may need to cut or bend the flange at the bottom
and the top of the 'Z' if it catches on the door jamb when
opening or closing (diagram 5).
DIAGRAM 5
before
5
If you need advice, call us
4
If you choose to vary from these instructions your warranty will be impaired.
2255mm channel.
H
gable plate with a 90 degree
L
after
FREE
on
0800 807 433
or email us at [email protected]
C
C
H
Channels will end 15-20mm short at tops
of end walls and 10-15mm at bottoms.
door with padbolt
YOU WILL NEED:
4x Sloping sheets & 2x Gable cut sheets for
C
the centre of the end walls
2 x 2255mm channels for bottom &
H
2 x 2290mm channels for top of end walls
2 x small gable plates for the outer
L
& 2 x small for the inner
H
L
C
YOU WILL NEED:
2 x 'Z' Door braces
N
M
Rivets as supplied
Locking T handle
Z door braces in position on
the inside of door sheet
L
ABOVE