Jancy Engineering Slugger MCCS14-2 Manuale dell'operatore - Pagina 5
Sfoglia online o scarica il pdf Manuale dell'operatore per Cutter Jancy Engineering Slugger MCCS14-2. Jancy Engineering Slugger MCCS14-2 16. 14" metal cutter
Stampa la pagina
• Avoid body contact with grounded surfaces such as pipes, radiators, ranges and refrigerators. There is an
increased risk of electric shock if your body is grounded.
• Don't expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
• Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away
from heat, oil, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords increase
the risk of electric shock.
• When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W." These cords
are rated for outdoor use and reduce the risk of electric shock.
(Note) When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Jancy recommends using a
minimum 12 gauge extension cord not to exceed 100 feet. The table below (Figure B) is supplied only as a guide to
minimum gauge for extension cords, where the smaller the gauge number, the heavier the cord.
MOTOR SAFETY AND PROTECTION
• Important: To avoid motor damage, this motor should be blown out or vacuumed frequently to keep dust from
interfering with normal ventilation.
1. Connect this tool to a power source with appropriate voltage for your model and a 20-amp circuit. The
wrong size circuit can damage the motor.
2. If the motor won't start, release the trigger switch immediately. Unplug the tool. Check the saw blade to make
sure it turns freely. If the blade is free, refer to Basic Troubleshooting section on pg. 13.
3. If the motor suddenly stalls while cutting, release trigger switch, unplug the tool and free the blade from
the work piece. The motor may now be restarted and the cut finished.
4. Fuses may "blow" or circuit breakers may trip frequently if:
a: Motor is overloaded-Overloading can occur if you feed too rapidly or make too many start/stops in
b: Line voltages should not be more than 10% above or below the nameplate voltage. For heavy loads,
c: Improper or dull saw blade used.
Fig. A
general safety rules
a short time.
however, the voltage at motor terminals must equal the voltage specified for your model.
(
cont
minimum gauge for extension cords
volts
total length of cord in feet
120V
0-25
26-50
240V
0-50
51-100
amperage
0-6
18
16
6-10
18
16
10-12
16
16
12-16
14
12
recommended wire gauge
:
note
jancy recommends using a minimum
100
.
sion cord not to exceed
feet
Fig. B
.)
51-100
101-150
101-200 201-300
16
14
14
12
14
12
not recommended
12
-
gauge exten
5