KitchenAid 30" Freestanding Range Manuale di istruzioni per l'installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Forno KitchenAid 30" Freestanding Range. KitchenAid 30" Freestanding Range 13. (61cm), (68.6cm), and (76.2cm) indoor/outdoor electric warming drawer
Anche per KitchenAid 30" Freestanding Range: Manuale di istruzioni per l'installazione (8 pagine), Istruzioni per l'installazione (5 pagine), Istruzioni per l'installazione (5 pagine), Manuale di istruzioni per l'installazione (16 pagine)

Stampa la pagina

Parts supplied:

2 plastic

anchors

2 screws

(#10 x 1-1/2")

Bracket must be securely mounted to sub-floor.

Thickness of flooring may require longer screws to

anchor bracket to sub-floor. Longer screws are

available from your local hardware store.

• burner grates and caps

• vent cap

• L.P conversion orifice spud kit:

1 – 0.95 mm cooktop (blue)

2 – 0.67 mm cooktop (black)

1 – 1.05 mm cooktop (green)

1 – #65 broil burner

Electrical requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can

result in death, fire, or electrical shock.

If codes permit and a separate ground

wire is used, it is recommended that a

qualified electrician determine that the

ground path is adequate and that the

outlet is correctly polarized.

Do not ground to a gas pipe.

Check with a qualified electrician if you

are not sure range is properly grounded.

A 120-volt, 60-Hz, AC-only, 10-ampere,

fused electrical supply is required. A

time-delay fuse or circuit breaker is

recommended. It is recommended that a

separate circuit serving only this

appliance be provided.

Tools needed:

Assemble the required tools and parts

before starting installation. Read and

Not shown:

follow the instructions provided with any

• literature pack

tools listed here.

• orifice spuds

• level

• flat-blade screwdriver

floor-mounted

• Phillips screwdriver

anti-tip bracket

• putty knife

• pipe wrench

• 3/8" drive ratchet

• 3/8" and 5/16" combination wrenches

• hand or electric drill

• channel lock pliers

• measuring tape or ruler

• wood floors: 1/8" drill bit

• concrete/ceramic floors:

3/16" carbide-tipped masonry drill bit

(Hammer may be needed for anchors.)

Electronic ignition systems operate

within wide voltage limits, but proper

grounding and polarity are necessary.

In addition to checking that the outlet is

correctly grounded, the outlet must be

checked by a qualified electrician to see if

it is wired with correct polarity.

IMPORTANT: This range is equipped with

an electronic ignition system that will not

operate if plugged into an outlet that is

not properly polarized.

A wiring diagram is included on the back

of the range.

See "Cabinet dimensions/requirements"

for recommended location of electrical

outlet.

Recommended ground

method

For personal safety, this range is

equipped with a power supply cord

having a 3 prong ground plug. To

minimize possible shock hazard, the cord

must be plugged into a mating 3 prong,

ground-type outlet, grounded in

accordance with the National Electrical

Code, ANSI/NFPA 70 — latest edition*, or

CSA Standard C22.1 Canadian Electrical

Code, Part 1 — latest edition**, and all

local codes and ordinances.

Materials needed:

• gas line shutoff valve

• 1/2" male pipe thread nipple for connection

to pressure regulator

• L.P. gas-resistant pipe-joint compound

• AGA or CSA design-certified flexible metal

appliance connector (4-5 feet) (1.2-1.5 m) or

rigid gas supply line as needed

• Insulated pad or 1/4" (6 mm) plywood if

range is installed over carpeting

If a mating outlet is not available, it is the

personal responsibility and obligation of

the customer to have a properly

polarized and grounded, 3 prong outlet

installed by a qualified electrician.

3 prong properly polarized

ground-type outlet

3 prong

ground plug

ground

prong

power supply

cord

Copies of the standards listed may be obtained

from:

* National Fire Protection Association

One Batterymarch Park

Quincy, Massachusetts, 02269

** CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575